GE GSC700, Инструкция по использованию и уходу

Страница: 8 / 20

Good with Water
To get dishes clean and dry, you need hot water. For good washing and drying,
the entering water must beat least 120°F. To prevent dish damage,
water not exceed
How to Test Water Temperature
Check your water temperature with a candy or meat temperatures unusually .
thermometer. Turn on the hot water faucet nearest low, or if your water travels a long distance from water
the dishwasher. the thermometer in a glass and heater to dishwasher, you may need to set your water
let the water continuously into the glass until the heater’s thermostat up. If you have not used hot water
temperature stops rising. If water temperature is for some time, the water in pipes will be Turn
below 120°F., adjust your water heater. on the hot water faucet at the sink and allow it to run
until
water is hot. Then start the dishwasher. If
you’ve done laundry or run hot water for
showers, give your water heater time to recover before
operating the dishwasher.
To improve washability if the water is less than
120°F. and you cannot adjust your water heater:
Select a longer cycle and fill both detergent cups
at least half-full with detergent.
How to Use a Agent
The rinse agent makes water flow off dishes
quicker than usual. This lessens water spotting
and makes drying faster, too.
For best performance, use of a rinse
agent such as brand is recommended.
Rinse agents come in either liquid or solid form.
Your dishwasher uses the liquid form.
How to the rinse agent dispenser:
Unscrew the cap.
Add
rinse
until it just
reaches the bottom of
lip inside the dispenser
opening. Replace cap.
The dispenser
automatically releases
rinse agent into
rinse water.
Your dishwasher’s rinse agent container holds
approximately
ounces. This should last about
3 months. Fill as needed.
you Wipe up the rinse
agent with a damp cloth. Don’t leave the spill in the
dishwasher. It can keep your detergent from working.
you can’t find any rinse write:
CONSUMER PRODUCTS,
(“ET-DRY”)
Corporate Centre 1
55
Road
Box 1991
Danbury, CT 06813-1991
You may check to see if you need to add rinse agent
by removing the cap and looking into the
container. You may check the rinse agent, on
some models, by pressing the clear center of the
cap 2 or 3 times. If rinse agent is drawn into the center
of the fill cap, you have enough. If the center area
remains clear add rinse agent.