GE GSC700, Инструкция по использованию и уходу

Страница: 4 / 20

HOW TO USE=
Before operating your dishwasher the first time...
Attach the Faucet Adapter. The special faucet adapter
supplied with your dishwasher must be assembled to
the sink faucet before you can use your dishwasher.
The faucet adapter is designed to fit spouts
having or threads. You will find the
adapter two washers in the “Faucet Adapter”
packet in your dishwasher.
To faucet adapter, remove the old aerator
or trim ring on your faucet spout.
faucet threads:
Insert the thinner of the two
washers into the faucet adapter
and attach it to the faucet spout.
Tighten with pliers.
faucet has internal
both of the washers into
the faucet adapter and attach it
to the faucet spout.
Tighten with pliers.
the faucet adapter
do not match your faucet
your local hardware or plumbing
supply store normally has
fittings to adapt your faucet spout to
d-
0
the
special faucet adapter.
NOTE:
A
sink spray attachment can burst
is installed on the same sink with your dishwasher
We
suggest you disconnect the sink spray
attachment sink has one the hole.
How to connect the Unicouple
1. Unicouple and its hoses completely out from
storage compartment located at rear of dishwasher
and attach it to the faucet adapter.
2. Attach Unicouple
faucet adapter by
collar at the top
of the connector.
-
Unicouple
is the way up
onto the adapter,
release the collar. It will then
snap into position to lock the Unicouple in place.
The small hose carries water from
the faucet to the dishwasher. Its large hose carries
drain water to the sink. Be sure Unicouple is
pointing toward the
sink
bowl drain opening and
the sink drain is open for water that will drain from
your dishwasher. If your dishwasher drains into a
disposer, operate the disposer until it is completely
empty before starting the dishwasher.
3. Turn hot water on before starting the dishwasher.
How to disconnect the Unicouple from faucet adapter
1. Turn off the hot water. 3. Release Unicouple from faucet by depressing
2. Release the water pressure by depressing
the collar at the top of the Unicouple connector.
pressure release button. This relieves water
pressure and protects you, and the room, from
severe splashing.
How to disconnect your dishwasher
1. Remove the power cord plug from the
NOTE: motor stops at the end of the
receptacle. rinse, the Unicouple can be disconnected returned
2. Disconnect Unicouple from faucet adapter.
to storage.
4