GE eBike with Control Terminal PC, Руководство оператора

Страница: 55 / 172

Running an Exercise Test
2018112-001 Revision B eBike with Control Terminal PC 19
Figure 4-8 Manual mode
Figure 4-9 Manual Mode
4.4 Manual
Selecting and Starting the Operating Mode
In this operating mode, you have to control the ergometer
manually, i.e., initial load, load increase, etc. have to be
entered manually. Blood-pressure measurements, too,
have to be started with the button.
y
Using the right and left softkeys in the main menu,
position the bar cursor on Manual, then press the
softkey in the middle to Select the option.
The initial screen appears (Figure 4-8).
y
Adjust the initial load with the right and left softkeys.
The increment is configurable between 1 and 25 W.
y
When you have finished preparing the patient, Start
the test with the softkey in the middle.
The ergometer will emit three beeps and the speed
display will blink three times to indicate the beginning of
the test. The exercise test clock will start at the same time.
Now the patient should begin pedaling.
The button label Start will change to End (Figure 4-9).
With this button, you can terminate the test.
There is no recovery phase in the manual mode.
W a t t
2 5 0 0
m i n / m i n
m m H g
/
/ m i n
S t a r t + 5 W - 5 W
W a t t
2 5 5 8 1 5
m i n / m i n
m m H g
/
/ m i n
E n d + 5 W - 5 W
Note
The device may be configured to default to one of
the operating modes. In this case you will see the
initial screen of the selected operating mode instead
of the main menu. You can display the main menu
with the button (see section 6
"Configuration").
NIBP