GE DCCH480EK, Техническое обслуживание руководство

Страница: 42 / 49

– 42 –
Rear Drum Seal Assembly
The rear drum seal assembly consists of a felt seal
that is permanently attached to a rubber gasket
and a circular bracket.
The rubber gasket is attached to the back of the
circular bracket with 6 rubber tabs. The circular
bracket is attached to the inside of the cabinet with
3 Phillips-head screws and 2 metal tabs.
WARNING: Sharp edges may be exposed when
replacing the rear drum seal. Use caution to avoid
injury. Wear Kevlar gloves or equivalent protection.
To remove the rear drum seal:
1. Remove the drum. (See
Drum and Bearing
.)
2. Remove the 3 Phillips-head screws from the
circular bracket.
3. Rotate the rear drum seal assembly 1/2-inch
counterclockwise, then pull the rear drum seal
assembly straight out from the cabinet.
4. At each tab location, pull the rubber gasket
away from the circular bracket.
Tab
Tab
Felt Seal Rubber Gasket
Tab
Bearing
7. Remove the 4 Phillips-head screws that attach
the bearing to the cabinet, and then release the
tab located at the top.
Belt Switch
The belt switch is located on the motor support
housing. The switch is activated by the movement
of the motor assembly. If the drive belt breaks or
comes off the motor pulley, the belt switch opens
power to the motor only.
Note: The drum lamp will operate with an open belt
switch.
To remove the belt switch:
1. Remove the drum. (See
Drum and Bearing
.)
2. Disconnect the wire harness from the belt
switch.
3. Press two tabs and remove switch from motor
support housing.
Disconnect
Tab
Tab
Belt Switch