GE DBSR453EBWW, Руководство по установке

Страница: 4 / 8

4
4 EXHAUST CONNECTION
5 LEVELING AND STABILIZING
YOUR DRYER
Installation Instructions
WARNING - TO REDUCE THE RISK
OF FIRE OR PERSONAL INJURY:
STANDARD REAR EXHAUST
(Vented at floor level)
STANDARD REAR EXHAUST
(Vented above floor level)
• Exhausting the dryer to the outdoors is strongly recom-
mended to prevent large amounts of moisture from
being blown into the room.
• Use only metal duct.
• Do not terminate exhaust in a chimney, any gas vent,
under an enclosed floor (crawl space), or into an attic.
The accumulated lint could create a fire hazard.
• Provide an access for inspection and cleaning of the
exhaust system, especially at turns. Inspect and clean at
least once a year.
• Never terminate the exhaust into a common duct with a
kitchen exhaust. A combination of lint and grease could
create a fire hazard.
• Do not obstruct incoming or exhausted air.
THIS DRYER COMES READY FOR REAR
EXHAUSTING. IF SPACE IS LIMITED, USE
THE INSTRUCTIONS IN SECTION 9 TO
EXHAUST DIRECTLY FROM THE SIDES OR
BOTTOM OF THE CABINET.
RECOMMENDED
CONFIGURATION
TO MINIMIZE
EXHAUST
BLOCKAGE.
ELBOW HIGHLY
RECOMMENDED
ELBOW HIGHLY
RECOMMENDED
NOTE: ELBOWS WILL PREVENT DUCT
KINKING AND COLLAPSING.
LEVEL
SIDE-TO-SIDE.
4 LEVELING
LEGS
LEVEL
FRONT-TO-BACK.
STAND THE DRYER UPRIGHT NEAR THE FINAL LOCATION AND ADJUST
THE 4 LEVELING LEGS, AT THE CORNERS, TO ENSURE THAT THE DRYER
IS LEVEL FROM SIDE TO SIDE AND FRONT TO REAR.
CUT THE METAL EXHAUST
DUCT (NOT SUPPLIED) TO THE
PROPER LENGTH.
(CORD NOT SUPPLIED
WITH DRYER)
NOTE: WE STRONGLY RECOMMEND SOLID METAL EXHAUST DUCTING.
HOWEVER, IF FLEXIBLE DUCTING IS USED IT
MUST BE METAL NOT PLASTIC.
FOR STRAIGHT
LINE INSTALLATION,
CONNECT THE
DRYER EXHAUST
TO THE EXTERNAL
EXHAUST HOOD USING
DUCT TAPE OR CLAMP.