GE Corometrics 250cx Series, Руководство оператора

Страница: 243 / 250

Revision C 250cx Series Maternal/Fetal Monitor D-9
2036946-001
Frequently Asked Questions:
How do I enable or change alarm volume
settings for Fetal Heart Rate 2? 1. Rotate the Trim Knob to highlight the legend for FHR2. (This legend is top left on the
display, and may display as INOP or US2.
2. Once the FHR2 legend is highlighted, press the Trim Knob. The display changes to
show the <MODE> Setup screen, where mode is the current legend.
3. Now rotate the Trim Knob to highlight the FHR2 Audio Alarms: setting. This is at the
bottom of the flat panel display, slightly above the menu bar, on the left half of the
screen. The setting is either On or Off. If the setting is Off, you must enable it.
Proceed to (Step 4) below. If the setting is already On, and you simply wish to
change the Volume: setting, proceed to (Step 7) below.
4. Once the Audio Alarms: setting is highlighted, press the Trim Knob again. The
current setting displays in blinking inverse video.
5. Now rotate the Trim Knob to change the current setting to On.
6. Once you set the desired alarm value, press the Trim Knob to confirm your selection.
The current value setting stops blinking.
7. Now rotate the Trim Knob to select (highlight) the Volume: setting located
immediately to the right. The setting is in the range of 1 to 9.
8. Once the Volume: setting is highlighted, press the Trim Knob again. The current
setting displays in blinking inverse video, and an audio tone, indicative of the alarm
volume, will be emitted from the speaker.
9. Now rotate the Trim Knob to change the current setting as desired. With each setting
change, an audio tone, indicative of the alarm volume, will be emitted from the
speaker.
10. Once you set the desired alarm value, press the Trim Knob to confirm your
selection. The current value setting stops blinking. A final audio tone, indicative of the
alarm volume, is emitted from the speaker.
11. Now rotate the Trim Knob to select (highlight) the Exit item on the bottom menu.
12. Press the Trim Knob again to return to the main monitoring display screen.
How do I enable or change alarm volume
settings for Non-Invasive Blood Pressure? 1. Rotate the Trim Knob to highlight the legend for NIBP. (This legend is slightly above
center, on the left side of the display.)
2. Once the NIBP legend is highlighted, press the Trim Knob. The display changes to
show the NIBP Setup screen.
3. Now rotate the Trim Knob to select (highlight) the Volume: setting which is located
immediately to the right. The setting is in the range of 1 to 9.
4. Once the Volume: setting is highlighted, press the Trim Knob again. The current
setting displays in blinking inverse video, and an audio tone, indicative of the alarm
volume, is emitted from the speaker.
5. Now rotate the Trim Knob to change the current setting as desired. Each time you
change a setting, an audio tone, indicative of the alarm volume, will be emitted from
the speaker.
6. Once you set the desired alarm value, press the Trim Knob to confirm your selection.
The current value setting stops blinking. A final audio tone, indicative of the alarm
volume, is emitted from the speaker.
7. Now rotate the Trim Knob to select (highlight) the Exit item on the bottom menu.
8. Press the Trim Knob again to return to the main monitoring display screen.
Question Answer