Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
5
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. The
Timer
and
Sleep
features will reset to the original setting.
You may need to set a new time if desired.
Power Outage Recovery Feature
ge.com
When the air conditioner is turned on, it will
automatically start in the setting last used.
Cool Mode
Use the
Cool
mode with
High (3), Med (2)
or
Low (1)
fan for cooling. Use the
Increase
▲
/
Decrease
▼
pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to
Cool
, it will take approximately 3 minutes for
the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—
Select the
Cool
mode
and
High (3)
or
Med (2)
fan with a middle set
temperature.
For Maximum Cooling—
Select the
Cool
mode
and
High (3)
fan with a lower set temperature.
For Quieter & Nighttime Cooling—
Select the
Cool
mode and
Low (1)
fan with a middle set
temperature.
NOTE:
If you switch from a
Cool
setting to
Off
or to
a fan setting, wait at least 3 minutes before switching
back to a
Cool
setting.
Air Direction—Up and Down
(on some models)
Fingertip pressure on the horizontal louvers adjusts
the air direction up or down.
Fan Mode
Use the
Fan
at
High (3), Med (2)
or
Low (1)
to provide
air circulation and filtering without cooling. Since
fan only settings do not provide cooling, a
temperature setting will not be displayed.
Air Direction—Side-to-Side
(on some models)
The side-to-side air direction is adjusted by the
louver levers.
The vent control is located on the inside of the
air louvers in the lower right corner.
When set at
CLOSE
, only the air inside the room
will be circulated and conditioned. When set at
OPEN
, some inside air is exhausted outside.
Vent Control
(on some models)
To open the vent, push the lever to the right.
To close it, push it to the left.
Additional controls and important information.
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
