GE AquaTrans AT868, Краткое руководство

Страница: 35 / 67

Programming Site Data 2-9
September 2004
Fluid Type
1. The selections for fluid type vary depending on whether the
Tracking Window is enabled or disabled. Press [
W
]
and [
X
] to
select the desired fluid and press [ENTER] . Refer to Table 2-2
below for a list of available fluids.
2.
If you selected
OTHER
, enter the additional information required
by using the arrow keys. Press [
W
]
and [
X
] to move the cursor to
the desired location and press
[
S
]
and
[
T
]
to increase or
decrease the number. Then press
[ENTER]
.
Reynolds Correction
1. Using [
W
]
and [
X
], select
Activ
to activate the Reynolds
Correction Factor or select Off to deactivate the Reynolds
Correction Factor. Then press [ENTER] .
Note:
usually, Reynolds Correction should be set to
Activ
.
2.
Do one of the following:
•
If you selected OFF , enter the Calibration Factor and press
[ENTER]
. Then, proceed to one of the following sections:
•
Clamp-on Transducers - proceed to Number of Traverses
and Transducer Spacing on the next page.
•
Wetted Transducers - The meter returns to the
Channel PROGRAM
window. To complete initial setup of
the AT868, you must enter data in the
GLOBL-SYSTM
submenu on page 2-12.
•
If you selected
ACTIV
, proceed to KV Input Selection on the next
page.
Table 2-2: Fluid Types
Tracking Window = NO Tracking Window = YES
WATER W100 (Water, 0°-100°C)
OTHER W260 (Water, 0°-260°C)
Oil, Tracking
OTHER