(continued)
3.
WINDOWFILLER PANELS.
1.
Place cabinet on floor, bench or table.
Plastic
r
Frame
2. Slide the “I” section of the window filler panel
into the panel retainer on the side of the cabinet
as shown above. Do both sides.
Top View
3. Insert top and bottom legs of the window filler
panel frame into the channel in the top support
angle and bottom rail. Do both sides.
Plastic
Air Condition
Frame
Locking
Screw
Hole
“I” Section
Window Filler
Panel
4. Insert two Type A screws into holes in the top
leg of the filler panel frame. Do not tighten–legs
should slide easily.
4. LOCATE CABINETIN
1.
Open window and mark center of window stool.
2. Place cabinet in window with bottom stool
angle firmly seated over window stool as shown.
Bring window down temporarily behind top rail to
hold cabinet in place.
10
4.
CABINET IN
(continued)
3. Shift cabinet left or right as needed to line up
center of cabinet on center line marked on stool.
4. Fasten cabinet to window stool with 2 Type B
screws. (You may want to drill pilot holes.)
5.
INSTALL
Type C Screws and Locknuts
(2 required for each support bracket)
RIGHT
Type D Bolt*
LEFT
0
0
Sill Angle Bracket”
*(1 required for each
bracket)
1.
Hold each support
bracket flush against
outside of sill and
tight to bottom of
cabinet as shown.
Mark brackets at
top level of sill and
remove them.
2. Assemble sill angle brackets to support brackets at
positions previously marked, as shown. Hand tighten
only—some adjustment may be required later.
3. Install support brackets, with sill angle
brackets attached, to cabinet as shown.
4. Tighten all 6 bolts and screws securely.
