6. EXTEND WINDOWFILLER PANELS.
Carefully raise window to expose filler panel
locking screws. Loosen screws so panels slide easily.
2. Extend panels to fill window opening
completely and tighten locking screws on top.
3. Close window behind top rail.
WINDOWLOCK
AND SASH SEAL.
Trim sash seal to fit window width and insert
into space between upper and lower sashes.
2. Attach right angle safety lock with Type B
screw as shown.
3. Position bottom rail seal on bottom rail flush with
front edge of rail and in contact with side seals.
8. SLIDE CHASSIS INTO CABINET
Be sure handle at bottom of unit is up. Then lift
chassis and carefully slide it into cabinet. Do not
push on controls or finned coils. Make sure
chassis is firmly seated toward rear of cabinet.
9.
DIAL
KNOBS, IF NECESSARY
I
---
If dial plate has a protective film, peel the film off
carefully. Do not scratch the surface of the plate.
Remove inlet baffle (see page 6).
2. Attach front grille to unit (see page 13, step 6).
Reinstall inlet baffle (see page 6).
(continued next page)
11
