GE Advantium SCA2000BCC, Руководство по обслуживанию

Страница: 62 / 62

– 60 –
Microwave Sensor Cooking
If you want to microwave sensor cook, and the
oven is already hot from previous speedcooking,
the display may indicate that it is too hot for sen-
sor cooking - this is normal. Of course, you can
always continue with
TIME COOK or SPEEDCOOK
.
Child Lock-Out
The control panel can be locked-out to prevent
the oven from accidentally being started or used
by children.
Press and hold the CLEAR/OFF pad for approxi-
mately 3 seconds to lock-out the control panel.
To unlock the control panel, perform the same
step.
Door Removal
To remove the oven door open it a full 90° (see
illustration below). With the door open, lift up-
ward on the door to disengage the top hinge.
Gently pull backwards on the top of the door to
totally release it from the hinge, while at the same
time lifting upward to remove the door from the
lower hinge.
IMPORTANT NOTE:
A microwave leakage test
must be performed any time a door is removed,
replaced, disassembled, or adjusted for any rea-
son. The
maximum allowable leakage is 4MW/
CM 2 (see page 48).
Cleaning
Clean the inside of
the oven after each
use. Some spatters
can be removed
with a paper
towel, others
may require a
war m soapy
cloth. Remove greasy spatters with a sudsy cloth,
then rinse with a damp cloth.
Do not use abrasive cleaners or sharp utensils
on oven walls. Never use a commercial oven
cleaner on any part of your oven. Do not clean
the inside of the oven with metal scouring pads.
Both the upper and lower halogen lamp covers
must be kept free of grease and food spatterings
in order to operate effectively. To clean the up-
per and lower lamp covers, remove the turntable.
Wipe the covers with a warm soapy cloth or plas-
tic scrubbie.
For heavy burned on soil, a cleaning scraper may
be used to clean the halogen lamp covers.
Do not use cleaners containing ammonia or al-
cohol on the outside of the oven because they
can damage the oven.
To clean the vent filters, soak them and then swish
them around in a hot water and detergent solu-
tion. Don’t use ammonia or ammonia products
because they will darken the metal.