64
MDS TransNET Ref. Manual
MDS 05-2708A01, Rev. F
in order to reduce the interference to the point where overload of one network
by the other will not occur. The
CSADDR
command will provide relief from
this antenna separation requirement by operating the networks in a TDD
mode and ensuring that one Master cannot transmit while the other (or
multiple others) are trying to receive a signal from a distant radio.
Master Station Configuration
On all Masters for which you wish to synchronize transmissions, establish
one Master as the “Clock-Sync Master by setting its
CSADDR
value to it own
Network Address (
ADDR
xxxxx
). Then, set all other dependent Masters
CSADDR
values to the Network Address (
ADDR
) of the Clock-Sync Master.
Make sure that you use a different Network Address (
ADDR
) for each Master.
This value will be used to identify all units associated with this Master’s
network.
Note that all Masters must be set to the same
CSADDR
setting, but only one
where the
CSADDR
matches its own
ADDR
; this is the Clock-Sync Master.
CSADDR = ADDR
—Unit serving as a Clock-Sync Master
CSADDR
ADDR
—Unit serves as a Dependent Master (Clock Slave)
CSADDR = NONE
—Co-located Master feature disabled (default)
HOPTIME
,
FEC
and
SAF
values are provided by the Clock-Sync Master to all
dependent units.
NOTE:
If a Dependent Master station is unable to find the Clock-Sync Master station, it
will not be able to operate properly and the associated network will be
out-of-service.
Antenna System for Co-Located Master Stations
Using this TDD (Clock-Sync) mode will prevent any two Masters from trans-
mitting and receiving at the same time and greatly reduce the antenna separa-
tion requirements to near zero. Under this arrangement, the antennas of
co-located Masters may be placed a few feet (less than a meter) apart horizon-
tally, or just above or below vertically with no ill effects. There are two
common antenna system arrangements:
Sharing a Common Antenna System
It is possible to share an antenna between multiple Masters using stan-
dard power dividers, as long as the extra loss associated with these
devices is taken into account in your RF budgeting process. Masters in
this configuration must be operating with Clock-Sync (
CSADDR
)
enabled.
Ideally, co-located Masters should use separate antennas. They can
share an antenna only if isolation is sufficient. If sufficient isolation is
not guaranteed, degraded performance will result. For example, the two
Master stations shown in
are connected to a com-
mon antenna system. They use a power-divider that will result in a sig-
nal loss of 3 dB, or one-half power level, on both transmit and receive
signals.
The power divider, such as a Mini-Circuits ZAPD-1 or similar product,
