5
Wall Control Syncing
Step 2. Install the 23A 12V battery provided.
Hold button to cycle between maximum and
minimum light.
Step 3. Within 30 sec, switch the lock “ ” / unlock
“ ” switch on the front of the transmitter to lock
position. And then push the sync “ ” button for
approximately 5-10 sec, until the fan light kit
flashes 3 times.
Step 1.
Switch off the power to the fan.
Step .
2 Use the on/off switch on the transmitter to
Trouble Shooting
CAUTION: Shut off main power supply before carrying out any of these checks.
In Case Of Interference With Several Fans, You Can Change
The Transmitter Code To Operate A Single Fan Only.
1. Fan will not start:
-Check
main
and
branch
circuit
fuses
or
breakers
.
-Check
to
make
sure
the
wall
switch
is
in
the
on
position
.
2. Remote control will not work:
-
Ensure the control is wired correctly and receiving power.
- Ensure
battery is
new
and
installed
correctly
.
- Ensure the switches are set correctly.
- Sync the remote by following the syncing procedure above.
turn power on to the fan.
