- 11 -
October 17
th
, 2019
Installation Manual for SR-1000 Standalone Media Player
3. Hardware Installation & Setup
3.3 Connecting the SR-1000 with the Projector
The SR-1000 Media Block should
be connected to the Projector’s link decryptor board using HD-
SDI cables. Take note of the following connections:
•
Connect '
SDI-OUT1
' from the Media Block to input '
A
' on the Link Decryptor
•
Connect '
SDI-OUT2
' from the Media Block to input '
B
' on the Link Decryptor
A network connection is required from
either the Media Block’s
ETH1
or
ETH2
to the Projector
’s
network port. Connect a network cable between the Media Block Ethernet port (
ETH1
or
ETH2)
to
the Projector. Configure the
ETH1/ETH2
IP address from the WebUI interface under
System >>
Network Configuration
.
Figure 9: Metal Chassis with Media Block inserted (front view)
Figure 8: Side railings of Metal Chassis with Media Block inserted
Note: The SR-1000 ETH1/ETH2 IP Address should belong to the same subnet as the
Projector’s IP Address.