37-1-614 Page 36
SECTION 6
DISASSEMBLY INSTRUCTIONS
FIGURE 6-1
– ADAPTOR PLATE
FIGURE 6-2 –
EARING PRESS PLATE
NOTICE
Illustrations for Disassembly Instructions are taken from various sizes of CycloBlower. Minor
variations in construction of some parts need cause no concern.
1. Provide adaptor plates, (Figure 6-1), and bearing press plate, (Figure 6-2), for pulling the gear
hub and pinion, and for installing bearings.
2. Provide bearing press plate, (FIGURE 6-2), for pulling the pinion gear and for installing the
main rotor bearings.
Pulling directly on pinion teeth will cause gear wear. Pulling directly
on the gear hub flange will distort the flange causing gear run-out
. The adaptor plates
shown are designed for a jaw type hydraulic puller, (Figure 6-4, and Figure 6-5, page 36 & 37).
Other type pullers are available, and if used, suitable adaptor plates should be provided.
FIGURE 6-3 – SPANNER WRENCH
FIGURE 6-4
– BEARING PRESS PLATE
