DU-KP-0002-61 Rev D 3/23/06 GCX Corp. Page 2 of 4
Tilt Tension Screws
Mounting Flat Panel Display on VESA Mounting Plate
Installation Note:
The Roll Stand Kit is equipped at the factory for mounting a typical 15'' or 17'' flat panel display.
1. Adjust Roll Stand Post to fully extended height to facilitate mounting of display.
2. Mount display on VESA Mounting Plate using M4 PHMS from
Mounting Kit for 75
/
100mm VESA® Compatible Flat
Panel Displays
(separate installation guide also provided).
3. Using a 7/16'' wrench, move the
Adjustable Stop (below left) to a position in the slot that will prevent the display from
being inadvertently lowered onto the Mounting Bracket. Placement of Adjustable Stop depends on height of display
housing.
Adjusting Height of Display
Loosen Knob, slide display to desired height and tighten Knob (above right).
Adjusting Tension of Vertical Display-Adjustment
Remove plastic bolt cap. Using a 1/2'' wrench, tighten or loosen tension adjustment nut (above right).
Adjusting Tilt Tension
Using the 5/32'' hex key provided, equally loosen or
tighten two (2) socket head cap screws on top of the Tilt
Clamp (right).
Tension Adjustment
Adjustable Stop
Mounting Adapter
(100 mm x 100mm)
Height Adjustment
M4 PHMS (4)