GBC PRO-TECH DS-60, Руководство по эксплуатации и обслуживанию

Страница: 18 / 36

Operation DS-60 Operation and Maintenance Manual
3-2 © GBC Pro-Tech 1998 January
2SHUDWRU&RQWUROV
The operator controls for the DS-60 Heat Press are
located on the front and rear of the unit, to the right of
the operator position. The names and functions of these
controls are as follows:
&RQWURO 3DQHO
Figure 3-3: Control Panel
1. ROLL PRESSURE DISPLAY - Displays the
pressure pushing the main roll down.
2. SPEED ADJUSTMENT – Adjusts the speed of
the machine from zero to the maximum as the con-
trol is turned clockwise. (Turtle is slow, rabbit is
fast.)
3. SLOW MODE CONTROL – Switches the photo-
electric eye system on and off. If the left side of the
toggle switch is pressed, the photoelectric eye sys-
tem is on and the heat press runs at any speed. If
the right side of the toggle switch is pressed, the
photoelectric eye system is off and the heat press
runs only by using the footswitch and only at
1 m/min maximum speed.
4. UPPER ROLL HEATER CONTROLLER –
Provides a readout of the temperature of the upper
roll and the set-point for the desired temperature.
5. UPPER ROLL HEAT ON/OFF – Turns the
heater controller for the upper main roll on or off.
6. TACHOMETER/COUNTER DISPLAY – Dis-
plays the operational rate or the amount of material
processed.
7. MOTION CONTROL FORWARD/REVERSE -
Controls the direction of the drive system, forward,
reverse, or stop.
8. RUN/STOP – Turns the drive system on or off.
9. PHOTOELECTRIC EYE RESET – Resets the
photoelectric eye system. (The photoelectric eye
system must be reset any time the heat press is
turned off and back on.)
6HWXS
Setup of the DS-60 Heat Press is quick and straightfor-
ward when instructions are followed exactly.
To adjust the nip, please see Maintenance.
+HDW 3UHVV 5ROO 3UHVVXUH
Use only the minimum amount of roll pressure needed
to accomplish the task. Excess pressure can damage the
rolls. Wrinkles and ripples have causes that generally
cannot be cured by applying more pressure.
CAUTION
A maximum roll pressure for dye sublimation is 40% at
390-400 ºF (199-204 ºC) with a suggested speed of 2-3
fpm (60-90 cpm).
CAL 3200
2
Speed
Adjustment
100
90
80
70
60
50
40
30
20
10
SEL RST
1 Roll
Pressure
Display
1 2 3 4 0 0 0 0
4
5
6
7
RUN/STOP 8
9
3 Slow Mode
Control
Tachometer/Counter
Display
Upper Roll Heat
ON/OFF
Motion Control
FORWARD/REVERSE
Photoelectric Eye
Reset
Upper Roll Heater
Controller
Excess pressure can damage the main rolls.
Minimum heat press roll pressure is consistent
with good results.