GBC PRO-TECH DS-60, Руководство по эксплуатации и обслуживанию

Страница: 29 / 36

DS-60 Operation and Maintenance Manual Maintenance and Troubleshooting
© GBC Pro-Tech 1998 January 4-5
/XEULFDWLRQ
Tools required:
•
1
/
8
" hex wrench
• High temperature grease or lithium grease
• Grease gun
To lubricate the heat press:
WARNING
WARNING
1. Remove the drive and control side cabinet covers
using the
1
/
8
" hex wrench by removing the six
screws holding each cover in place.
2. Using the grease gun, lubricate each grease fitting
with one squirt of high temperature grease.
3. Lubricate the chain using a soft cloth and automo-
tive oil.
4. Replace the cabinet covers, close the safety shields
and reapply power to the heat press.
&RQWDFWLQJ7HFKQLFDO6XSSRUW
For machine parts and technical service in North
America, please call: 1-800-790-7787. Please provide
serial number when calling for service. In Europe,
please call: +44 (0) 1844 202 440 or fax: +44 (0) 1844
202 441.
For film and application questions in North America,
please call 1-800-236-8843. In Europe, please call: +44
(0) 1844 202 440 or fax: +44 (0) 1844 202 441.
7URXEOHVKRRWLQJ
This section covers troubleshooting of the digital dye
sublimation finishing system. In almost all cases, unac-
ceptable finished image transfer quality is due to incor-
rect operational parameters for the heat press and
consumables being used to create the finished image.
To help eliminate some of the confusion, this guide
provides operational parameters for running of the var-
ious materials. These guides are an excellent starting
point, but there are instances where the suggested oper-
ational parameters may not produce acceptable output.
*KRVWLQJ
This is a term used to describe a shadowing of toner
around a transferred image, generally caused by exces-
sive moisture in the paper and/or fabric, or having
printed the image using four color black (too much
toner).
This can be remedied by either slowing down the pro-
cess and letting the machine pre-dry the fabric and
paper or by pre-drying the fabric and paper prior to
transfer.
:ULQNOLQJ
This is a term used to describe a wrinkle-like pattern in
the transferred image. It is generally caused by exces-
sive fabric shrinkage during the transfer.
This can be remedied by either slowing down the pro-
cess to let the fabric shrink some while the machine is
pre-heating it, or by pre-shrinking the fabric. Slowing
down the process only works if it is a minimal shrink-
age problem.
Wet paper can also cause wrinkling. This can be reme-
died by either slowing down the process to let the fab-
ric dry while the machine is pre-heating it, or by pre-
drying the fabric.
Do not lubricate the heat press when it is hot. You
can be burned.
Remove and lockout power from the heat press
while you are performing this procedure. You
could be severely shocked, electrocuted, or get
your fingers caught in the drive mechanisms.