GBC Magnapunch 2.0, Руководство по установке и эксплуатации

Страница: 28 / 120

Magnapunch 2.0
– Installation and Operating Instructions
Page 6-8
Press 6. NEXT . The LCD screen displays an image
similar to the ruler on the Die Set and shows
where the left Edge Guide should be placed.
Set Side Screen. Figure 28.
Slide the left Edge Guide to that position and 7.
press NEXT .
NOTE:
When positioning the left Edge Guide, the
right edge of the clear pointer should be placed on
the dot.
Setting Edge Guide On the Dot. Figure 29.
Following the instructions on the LCD UI, remove 8.
the Die Set from the Magnapunch 2.0, ensure
all pins are in place and then remove the pins
identified on the LCD UI. This will eliminate
punches at the edge of your document.
NOTE:
Each pin is labeled with a pin number on the
Die Set ruler.
Pin Configuration Screen. Figure 30.
Reinsert the Die Set into the Magnapunch 2.0. 9.
To leverage Die Set markings for common paper
sizes:
Common media sizes are displayed on the Die Set
label and have a line with a dot at the end identifying
where to set the left Edge Guide.
Insert the proper Die Set for the punch pattern 1.
required for the job.
On the
2. HOME screen, set the PUNCH mode to
foot pedal to avoid accidently cycling the punch.
Home Screen with Foot Pedal Selected. Figure 31.
Slide the left Edge Guide to the proper position 3.
based on your media size.
NOTE:
when positioning the left Edge Guide, the
right edge of the clear pointer should be placed on
the dot. See
“Figure 29. Setting Edge Guide On the
Dot.”
Insert your media to be punched and place 4.
against the left Edge Guide. Look at the Die Set
pins and identify any that need to be removed to
avoid punching the edge of your document.
Remove the Die Set and take out the pins if
5.
necessary.
Reinsert the Die Set.
6.
Set the Punch mode back to 7.
Trigger
if needed.
Sheet Sizes Larger Than the Maximum
Punch Width
Pointer on dot.