GBC Magnapunch 2.0, Руководство по установке и эксплуатации

Страница: 26 / 120

Magnapunch 2.0
– Installation and Operating Instructions
Page 6-6
C
hanGinG the
i
nteRChanGeaBle
d
ie
s
ets
Your Magnapunch 2.0 offers the convenience
of interchangeable Die Sets, allowing you to
economically punch documents for a wide variety of
binding styles.
R
eMovinG
d
ie
s
ets
To remove Die Sets from the Magnapunch 2.0:
The interchangeable Die Set slot of the Magnapunch
2.0 is located on the right front side of the
Magnapunch 2.0. If a Die Set is already installed in
your Magnapunch 2.0, you can easily remove the Die
Set.
Grab the Die Set handle by placing your palm on 1.
the front and wrapping your fingers behind the
handle (located on the right side of the Die Set).
Die Set Partially Pulled Out. Figure 24.
Securely grasp the handle and tug firmly. 2.
Continue pulling on the handle until the Die Set 3.
is fully removed. Support the Die Set with both
hands.
Properly store the removed Die Set (away from
4.
dust, dirt, falls, etc.).
Helpful Hint:
The GBC Die Set Storage Holder is
an excellent way to store your interchangeable Die
Sets for the Magnapunch 2.0. This holder securely
holds several Die Sets, protecting them from dirt,
dust, and potential damage. Contact your GBC sales
representative for information on obtaining a Die Set
Storage Holder.
i
nstallinG
d
ie
s
ets
CAUTIONS:
Possible pinch point hazard. When installing Die •
Sets into your Magnapunch 2.0, always keep
fingers and body parts out of the Magnapunch
2.0’s Die Set slot
and away from all areas of the
Die Set except for the finger groove in the Die
Set’s handle. Failure to observe these precautions
may result in injury.
Possible Die Set damage. Make certain that all
•
punch pins are fully and properly seated in the Die
Set before inserting the Die Set. Failure to ensure
that
all punch pins are fully seated could result in
damage to the Die Set and Magnapunch 2.0.
To install a Die Set:
Grab the Die Set handle by placing your palm on 1.
the front and wrapping your fingers behind the
handle (located on the right side of the Die Set).
Refer to
“Figure 24. Die Set Partially Pulled Out.”
Carefully align the leading edges of the Die 2.
Set’s support rails with the leading edges of the
Magnapunch 2.0’s guide rails.
Using your fingers in the Die Set’s handle, firmly
3.
push the Die Set into the Magnapunch 2.0’s Die
Set slot. You will hear a click when the automatic
locking mechanism engages. This mechanism
securely holds the Die Set during punching
operations.
Note:
If the Die Set is not properly inserted into the
Magnapunch 2.0 and locked into place, the LCD
displays an error.
Die Set handle.