GBC 27C, Руководство по установке и эксплуатации

Страница: 25 / 33

Operating Instructions
Page 6-8
27C
Fig. 6-13. New Films Tacked to Old Films.
Install the feed table and safety shield.
Set the speed for the slowest speed setting and
press
RUN
.
Watch the film being pulled through the laminator
to ensure that the remaining existing film and the
new film are advancing concurrently and evenly.
Any separation between the films will require
stopping the motor immediately and the situation
corrected.
Press
STOP
once the newly threaded film
completely exits the laminator.
Check the film alignment and adjust the tension
if needed.
See the
Film Alignment section in this chapter.
8.
9.
10.
11.
12.
D
ECALING IN
T
WO
P
ASSES
Decaling is where you laminate items and then
mount them on other materials such as Foam Core
or mounting board. It is performed in two passes.
The first pass laminates and applies the mounting
adhesive, encapsulating the item. The second pass
mounts it on rigid material.
This two pass operation requires pressure sensitive
laminating film on the top supply shaft and pressure
sensitive mounting film on the bottom supply shaft.
Refer to Fig. 6-15 for the proper configuration of
Poly-in or Poly-out film.
Fig. 6-14. Laminator Loaded for Decaling the First Pass
with Film (Poly-in Shown).
Fig. 6-15. Configurations for Poly-in and Poly-out Films.
Release liner
Take-up
PSA Film
PSA mounting film
Poly-in
Poly-out