02_340_001_AJ_BE(Rev 11/05/11)
(from French version : 02_340_000_AJ_BE (Rev 11/05/11)
Portable Inspectra Laser
©Copyright Gazomat
36/48
10.1.1 R
EPLACING THE FILTER INTEGRATED INTO THE DEVICE
The filter in the device is a hydrophobic filter with a fine retention limit (0.45 µm). It is
located on the underside of the device, in the filter housing.
The filter gets clogged immediately if any water enters the device, which stops the pump
automatically. The pump alarm is triggered and the operator needs to take action.
1
Switch the device off with a long press on the On/Off
button.
2
The housing for the hydrophobic filter is closed by a cap
with four holes.
3
Use the pin wrench to unscrew the cap of the
hydrophobic filter housing to replace the filter
4
Unscrew the knurled cap with the pin wrench. During
this operation, it is preferable to keep the filter enclosure
down, so that any water runs out of the unit.
5
Remove the hydrophobic filter and the black o-ring seal.
6
Check the filter condition (pollution by impurities and
water)
Check the condition of the seal.
