Gazer CKR4400, Руководство пользователя

Страница: 12 / 57

13
ENG
Note: To activate the CCTV parking mode, set switches No. 1 and No. 2 in “Down” position.
Attention! When installing switches No. 1 and No. 2 to the “Down” position and switches No. 3 and No. 4 to the “Up” position, a built-
in G-censor will be not active.
Setting up CCTV parking mode
Gazer surround view system supports CCTV function in a parked car. When this function is activated, the system stops operating after ACC
signal is off and plays back a 120 second video recording only if the shock sensor (G-sensor) is tripped. Car battery discharge control function
will prevent the car battery from a critical discharge: the system will shut down completely at 11.7 V until ACC signal is on again.
Use the switches on the device control unit to adjust the system further.
Switch No. 1 (“Up” position): force system shutdown after ACC signal is off.
Switch No. 2 (“Up” position): disable car power system voltage control (set at 11.7 V).
Switches No. 3 and No. 4: shock sensor (G-sensor) sensitivity adjustment. To adjust the shock sensor (G-sensor) sensitivity, set the
switches as shown in the diagram below:
G-sensor
Switch
№ 1 № 2 № 3 № 4
Off Up Up Up Up
Level 1 Down Down Down Up
Level 2 Down Down Up Down
Level 3 Down Down Down Down
Setting up procedures