Gazelle GW7030, Руководство пользователя, Страница: 8 / 12

8
EN
1
2
3
1.Handle
2.Auxiliary Handle
3.Base
CAUTIONS:
Do not stop the saw blade by lateral pressure on
the disc.
Attempt to avoid positioning which exposes
operator to chips and wood dust being ejected
from saw.
Use eye protection to help avoid injury.
Rip Fence
The handy rip fence allows you to do extra-accurate
straight cuts. Simply insert the guide plate to the holes
of the baseplate and then secure it in position with the
wing nut. It also makes repeated cuts of uniform width
possible.
1
2
1.Rip Fence
2.Wing Nut
Vacuum installation instructions
1.As shown in the figure below, the vacuuming
interface is secured to the guard by two screws.
1
2
3
1.Vacuuming
interface
2.Set Screw
3.Fixed Guard
2.As shown in the figure below, the vacuuming
interface is mounted on the guard.
1
2
3
1.Vacuuming
interface
2.Set Screw
3.Fixed Guard
3.As shown in the figure below, the vacuuming
interface and the vacuum cleaner can be connected
when needed.
1
2
3
4
1.Vacuuming
interface
2.Install
3.Remove
4.Vacuum
cleaner's tube
Vacuuming instructions
1
1.Vacuum Cleaner
MAINTENANCE AND CARE
Caution
:
Always be sure that the machine is
switched off and unplugged before attempting to
perform maintenance.
Replace the Carbon Brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at
the same time.
1
1.Limit Mark
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.