Gazelle GW7030, Руководство пользователя, Страница: 6 / 12

6
EN
A typical illustration
of proper hand
support,workpiece
support,and supply
cord routing.
WARNING: It is important to support the workpiece
properly and to hold the saw firmly to prevent loss of
control which could cause personal injury. The figure
below illustrates typical hand support of the saw.
j)Before sawing, you should determine whether the
adjustment of the saw depth and bevel is correct.
k)When a circular saw needs to be placed on the
machining part for cutting, place the tool on the
larger side of the workpiece and the smaller side
under the saw. Place the wider portion of the
saw base on that part of the workpiece which is
solidly supported, not on the section that will fall off
when the cut is made. As examples, the left figure
illustrates the RIGHT way to cut off the end of a
board, and the right figure the WRONG way. If the
workpiece is short or small, clamp it down. DO NOT
TRY TO HOLD SHORT PIECES BY HAND!
l) Never attempt to saw with the circular saw held
upside down in a vise. This is extremely dangerous
and can lead to serious accidents.
m) Before setting the tool down after completing a
cut, be sure that the lower (telescoping) guard has
closed and the blade has come to a complete stop.
INSTRUCTIONS FOR OPERATION
• Removing or Installing Saw Blade
The following blade can be used with this tool:
Max. Dia. mm 185
Min. Dia. mm 170
Inner Dia. mm 20(19)
Thickness mm 1.7
Kerf mm 1.9
Caution:
Do not use saw blades that do not match the
characteristics described in this manual.
• Removing Saw Blade
To remove the blade, press the spindle lock so that
the blade cannot revolve and use the hex wrench to
loosen the hex socket head bolt counterclockwise.
And then remove the bolt
,
outer flange and saw blade.
*CAUTION: Always be sure that the tool is
switched off and unplugged before installing or
removing the saw blade.
1
2
1.Lock Button
2.Hex Wrench
• Installing Saw Blade
To install the saw blade, follow the removal procedures
in reverse. Install the inner flange, saw blade, outer
flange and hex bolt, in that order. Be sure to secure
the hex bolt clockwise tightly with the spindle lock fully
depressed.