Gazelle GW7030, Руководство пользователя, Страница: 7 / 12

7
EN
1
2
3
4
1.Inner Flange
2.Saw Blade
3.Outer Flange
4.Hex Bolt
Cautions
·Be sure the blade is installed with teeth pointing
forward in the same direction as the tool rotation
(the arrow on the blade should point in the same
direction as the arrow on the tool).
·The inner flange is supplied for 2 types of saw
blades with the inner diameters of 20 mm and
19mm. The 19 mm diameter side is marked with
"19". Be sure to choose the correct side of the
inner flange for installation according to the
diameter of the blade. Improper installation may
result in dangerous vibration and cause serious
personal injury.
·Use only original wrench to remove or install the
blade.
1
2
3
4
5
1.Inner Flange
2.Drive Spindle
3.Mark (19 mm)
4.Outer Flange
Saw Blade
5.Hex Bolt
• Adjusting Depth of Cut
Loosen the lock lever for adjusting the cutting depth. At
a desired depth of cut, secure the base by tightening
the lever.
CAUTION:
Use a shallow depth of cut when cutting thin
workpiece for cleaner, safer cuts.
After adjusting the depth of cut, always tighten the
lever securely.
1
1.Lock Lever
• Bevel Cutting
Loosen the wing nut on the bevel gauge in front, and
tilt the tool to the desired angle for bevel cut (0°-45°).
Secure the wing nut on the bevel gauge tightly after
making the adjustment.
1
2
1.Bevel Gauge
2.Wing Nut
• Sighting
For straight cuts, align the right notch on the front of
the base with the cutting line on the workpiece. For
45° bevel cuts, align the left notch with it.
1 2
3
1.For 45° bevel cuts
2.For straight cuts
3.Base
• Switch Operation
To start the tool, first press the lock button, and pull the
switch trigger. Release the switch trigger to stop.
Caution: Before plugging in the tool, always check
to see that the switch trigger actuates properly
and returns to the “OFF” position when released.
To prevent the switch trigger from being
accidentally pulled, a lock-off button is provided
as a safety feature (Anti-self-locking).
1 2
1.Switch Trigger
2.Lock Button
• Operation
Hold the tool firmly. Set the base on the workpiece to
be cut without the blade making any contact. Then turn
the tool on and wait until the blade attains full speed.
Now simply move the tool forward over the workpiece
surface, keeping it flat and advancing smoothly until
the sawing is completed. To get clean cuts, keep
your sawing line straight and your speed of advance
uniform.