EN
16
16
MAINTANENCE & SAFETY
GAUSS MIL CARE:
Do not leave the detector in extreme cold or heat (e.g. in a hot car) as well as in damp locations.
Avoid getting sand and grit in the shafts and fastening parts (e.g. twist locks and coil assembly).
If there is a noticeable scratch on the lower shaft, wipe it thoroughly with a damp cloth.
Treat the detector coil with constant care, do not subject to strong shock and always remove
traces of dirt.
Remember that the detector coil is submersible whereas the control box isn’t. Never submerge
the control box in water!
Loosen the coil attachment bolt when the detector isn’t in use so that the coil mounting tabs
don’t experience excessive deformation to prevent cracks in the housing.
Rinse the coil and the shaft with fresh water after use on the beach. Do not wash the control box
by spraying or pouring water on it!
Before charging, remove metal particles accumulated on the magnetic cable connector.
Strictly follow the relevant instructions of this manual while charging the detector.
Ensure that the coil cable is in good condition and not subject to excessive stress.
Observe safety precautions when transporting or storing the detector. The device screen can get
scratches or serious damage if not treated with due care. Use a screen protector to keep it pristine.
Do not expose the detector to extreme temperatures. Operating temperature range: -20°C to
+45°C.
GENERAL CARE:
Do not use solvents to clean the detector. Wipe down with a cloth using warm soapy water or a
mild household detergent.
Do not expose the accessories to moisture or excess humidity, keep them away from liquids.
Do not open or distort the internal batteries.
Strictly follow the relevant instructions of this manual while charging the accessories.
Do not throw the detector or accessories into a fire as this may cause an explosion.
The Gauss MiL is a high-quality electronic device, therefore proper care and maintenance is
essential to ensure its continuous reliable operation.
For reliable and long-lasting operation, the Gauss MiL and MDLink batteries need to be
charged at least once every 3 months in a temperature range of 0°C to +
45°С.
The storage temperature range: -20°C to +45°C.
17
ERROR MESSAGES
During operation, the detector is capable of continuously monitoring the coil condition to
determine the coil disconnection or overload problem. If such situation occurs, a warning
message will be displayed in the Target ID field.
Move the coil away from the source of overload.
Ensure the coil connector is plugged into the control box
socket. Check the coil cable and housing for any visible
signs of damage.
Continue searching.
Код сповіщення
Overload
Coil Not Connected
Coil Connected
Необхідні дії
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
