15
EN
14
FACTORY SETTINGS
All settings are saved in the
Gauss MiL`s
memory after it’s turned off
and are automatically restored after it’s turned on.
1.
2.
3.
TO RETURN YOUR SETTINGS TO THEIR
FACTORY PRESETS, PERFORM THE
FOLLOWING STEPS:
Turn off the detector.
Press and hold , turn on the detector
using .
Hold down and wait until all options of the
Settings Menu briefly appear on the LCD screen.
15
TROUBLESHOOTING
Ensure the battery is sufficiently charged.
Connect the supplied charger to the detector and wait until charging is
complete.
1. Check the coil cable, make sure all the contacts are clean.
2. Ensure the nut on the coil connector is firmly tightened.
3. Move away from the source of interference.
4. Try switching to another operating frequency.
5. Reduce the detector’s sensitivity
Ensure the built-in transmitter is turned off.
Ensure both devices are set to the same channel.
Change the mounting spot of the MDLink module. It should be located
at a place where electromagnetic waves meet no barriers.
Rotate the twist lock in loosening direction and clean it out to remove
dirt and sand.
The detector turns on, but
turns off by itself
The detector doesn’t turn on
Erratic noises
No sound from the built-in
speaker
No connection with the
MDLink module
Unstable connection with the
MDLink module
The shaft twist lock seizes
Trouble
Solution
