GA-600S
3D Wheel Aligner User Manual
4-1
Chapter 4
Operation Instruction
4. 1 Preparation before test
1) Ask the owner for vehicle drivability problems, symptoms, and wheel alignment
history, and find out vehicle information such as make, model and year, etc.
2) Check and lock turntables and side slip plates, place the passing bridge, drive the
vehicle onto the lift, make front wheel about to be on the turntable center. When
the vehicle well on desired position, center the steering wheel, lock the steering
wheel with steering wheel holder. Place the parking rubber at back wheel, then
release handbrake. Lift the vehicle up to the alignment height.
3) Check each chassis part carefully, include dust cover, bearing, rock arm, tripod-ball,
shock absorber, tie rod ball and steering mechanism, for any loose or wear. Then
check to see if the tire pressure, tire treads of the left and right wheels are alike.
4) Mount the clamps and target onto the wheels, and lock the clamps.
5) Power up the wheel aligner computer.
4. 2 Software Operation
Switch on power, boot the computer, then the wheel alignment software will
automatically start.
There are 6 function buttons on the main interface: alignment check, System Settins,
General Settings, Print Report, help, exit. As show in Figure 4. 1.
Figure 4. 1
