Gateway GT4015, Справочник по аппаратуре

Страница: 32 / 78

Adding or replacing an expansion card www.gateway.com
29
Adding or replacing an expansion card
To add or replace an expansion card:
1
Remove the side panel by following the instructions in “Removing the side
panel” on page 12 .
2
If you are adding a new expansion card, go to the next step. If you are
replacing an expansion card, go to
Step 5 .
3
Disconnect any cables that are attached to the card, noting their locations
and orientation. (You may need to reconnect the cables after you install
the new card.)
4
Open the card retention lever.
5
Remove the old expansion card. You can slightly seesaw the card
end-to-end to loosen the card, but do not bend the card sideways.
Caution
Do not touch the contacts on the bottom
part of the expansion card. Touching the
contacts can cause electrostatic damage
to the card.
6
Install the new card into the expansion slot. You can slightly seesaw the
card end-to-end to help insert the card, but do not bend the card
sideways.
7
Reconnect the expansion card cables (if any) using your notes from Step 3 .
8
Replace the side panel.
Card retention lever