Gates Z3 Housing, Руководство по установке, использованию и уходу

Страница: 41 / 53

Z3 Setup Page 41
Seal Check
✓
Seal Check Manual. Follow the procedures in the Seal Check manual for verifying
integrity of the housing and monitor.
✓
CAUTION. Draw only about 100 millibars vacuum (Seal Check Lite and Seal Check
II kits) or 3 in Hg (Seal Check I) on Z3. More vacuum can inhibit the transfer of heat
away from the housing.
✓
Note that Seal Check Lite
–
included with Z3
– requires about 80 cycles hand
pumping to reach 100 millibars (3 in Hg) vacuum.
✓
CAUTION: ensure the Seal Check plug is installed and secure before diving.
Final Checks
✓
Visual Inspection. Look closely at all seal mates
– Port, SPR’s, and main Housing
seal
– for gaps. Look over the housing one final time.
✓
Verify operation. As a final check, power on the camera and verify all controls are
functioning normally.
The Seal Check fitting is located
here on the rear left of Z3.