Fig 11.
The control box should be equipped with a single-phase breaker (10A). Make sure that the
power is OFF before making any electrical connections. Remove the cover of the control box,
perform the wiring and replace the cover again. (See Fig.3 and wiring notes for control board)
Wire your AC line into the AC IN terminal on JX-1. Verify that all electrical connections are
waterproof by installing electrical outlets into exterior grade boxes with waterproof covers.
Make sure that whenever an electrical connecter enters or exits a box it is sealed. If using
solar, verify that all connections are waterproof and install solar power terminals into + and –
terminals in JX-5
RF Remote Control
Button 4
Button 3
Button 1
Button 2
Fig.12
The remote control works in a single channel mode. It has four buttons. The function of button
1, button 2, and button 3 are the same. With each press of the remote control button which
has been programmed, the gate will open, stop, close or stop cycle. Button 4 is available to
set pedestrian mode. Note: if you cancelled the pedestrian mode, the function of button 4 is
the same as the other three buttons.
Warning: Notify the users that the gate is never to be operated unless it is in full view.
OPERATOR SIDE
POWER INPUT
BLACK
BROWN
BLUE
BLACK
RED
BLUE BLUE
RED
RED
BRIDGE
RECTIFIER
MOSFET
TRANSFORMER
MOTOR
1
4
1
3
1
5
1
2
1
1
1
0
9
8
7
6
5
4
3
2
1
M
-
M
+
E
C
B
-
+
OPERATOR
NOT USED
NOT USED
NOT USED
NOT USED
NOT USED
NOT USED
COMMON
12VDC
N/O INPUT FOR PUSH
BUTTON AND KEYPAD
DC POWER INPUT
MOSFET
MOTOR
BUZZER
12VDC POSITIVE FOR PHOTOEYE
N.C. PHOTOEYE INPUT
COMMON
OPEN