- 37 -
Figure 26: SIM Card Dial Parameters.
FTP Settings
Not Supported
Route
Not Supported
Event
Sensor
Sensor setup consists of two pages of options which are user definable.
S1; S2 and S3 are pre-defined and factory
defaults are set for BRK (Brakes); WRN
(Warning Lights) and STPARM (Stop Arm).
S7 and S8 are currently unassigned and
reserved for future development. The OSD
setting is limited to two characters.
It is recommended that SET remain at its
factory defaults of HIGH.
Alarm determines if the Alarm LED will flash when the Sensor is activated.
LOCK sets if the recorded video file created by the sensor will be protected from being over-written as defined in the
Advanced
Record
Options (Options 2)
Alarm Output
THIS FEATURE IS CURRENTLY NOT SUPPORTED.
SPEED
There are 8 options available for setting within the Speed option. Some of these options are only available after other
selections have been made.
Please Note: An approved GPS antenna is required for the 304-SD to receive satellite signals for
speed.
Once the SPEED menu has been accessed, Speed Source can be
selected as either Vehicle or GPS. If Vehicle is selected please
consult the documentation which came with your vehicle to see
how to set up this connection.
If an approved GPS module has been fitted select GPS as the
Speed Source.
Speed Unit can be set to either MPH or KPH, select the correct
Speed Unit for your location.
To enable Speed check select the EN (short for Enable) menu and set to ON.
Next for either LOWSPEED or OVERSPEED set the THRESHOLD value. Use the Numeric keypad on the remote
control to set the required values.
To have an Alarm be registered when the THRESHOLD value has been reached or exceeded, set the ALARM
option to ON.
Once all selections have been made, highlight the OK button and press ENTER on the remote control.
