36 -
WI-FI
Wi-Fi can be configured for use of an internal Wi-Fi card, if installed, or for when an external Wi-Fi radio is being utilized. If an
external Wi-Fi radio is being used Wi-Fi ENABLE must be set to OFF.
If an internal wireless module is being utilized, please consult with your Information Technology department for all relevant IP;
DNS; Gateway and subnet information.
If Wi-Fi is enabled, I.E. using an internal Wi-Fi card,
there are two options once enable has been selected:
Figure 25: Example WI-FI Configuration.
Client:
Sets the 304-SD as a client on the
network. Once selected GET IP Type will
become available with two options; Static
IP and Dynamic IP. If Static is chosen
complete the required fields for IP; SUB;
and Gateway.
AP:
When AP is selected only the IP and SUB
fields require population with the required
information.
ESSID:
ESSID only becomes active once the PASSWORD ENABLE option has been chosen. Enter the required
ESSID, network name, for the wireless network.
PASSWORD ENABLE
Options:
WEP
WPA
Mobile Network
Please note: This function is currently reserved for future development.
If a mobile network is to be configured, the 304-SD will require the installation of a SIM card. The installation of the SIM card
must be done at time of system build at the Gatekeeper Systems Facility.
Remove the 4 retaining screws on the base of the 304-SD. The SD card slot located here is for future development.
Make sure to connect the 3G antenna to the rear of the 304-SD.
Module Type
Options
NONE; CDMA; EVDO; WCDMA; EDGE; TD-SCDMA
If EVDO is chosen, a secondary dialog window will appear with options for
2G3G / 2G / 3G.
Default: None
Active Mode
Options
Always; Call/SMS; Sensor. If Call/SMS is selected a secondary dialog
window will appear where up-to three phone numbers can be entered.
Dial Parameter
See Figure 25 for more information
Intercom Settings
Reserved for future development.
