![background image](http://html1.mh-extra.com/html/gastroback/advanced-pro-s/advanced-pro-s_operating-instructions-manual_568840057.webp)
EN
57
Problem
Possible Reasons
The Easy Solution
The fruit half turns with
the juicing cone.
Hard bulges at the tip ends
of the fruit halves cause
poor contact of the fruit
dome and the fruit shell.
Cut the bulges at the tip ends of the fruit flat. Then try
again.
The fruit half is too large.
The fruit halves may not be larger than the juicing cone
(max. 7 cm in height). When the fruit is pressed down via
the fruit dome, at least 1 cm (1/2 inch) of free space must
be left at the bottom of the juicing cone. Cut off an appro-
priate slice at the open end of the fruit half for getting good
contact to the juicing cone.
Note:
The fruit slices may be
used for decorating the glasses, when serving the juice.
The interior of the fruit
dome is obstructed by resi-
dues of the fruit shells.
Unplug the appliance and remove the fruit dome (see:
‘Operation / Disassembling the Appliance’). Then clean
the fruit dome. Thereafter, try again.
You need to press a little
harder on the press arm.
Increase the pressure on the press arm just until the fruit
half does not turn with the juicing cone.
There is a lot of white
and bitter inner shell in
the juice OR the pulp is
very wet.
You apply too much pres-
sure to the press arm.
When pressing too hard, the white inner shell of the fruit
may be scratched off and get into the juice—especially
when using the coarse filter basket. Decrease your juicing
speed by reducing the pressure on the press arm. Push
down the press arm just until the motor starts. This way,
you get the maximum amount of juice.
Not enough juice.
The fruit is somewhat dry
already.
Always use fresh fruit for juicing. Especially small citrus
fruit may get dry after some days of storage.
The fruit half is too large.
The fruit halves may not be larger than the juicing cone
(max. 7 cm in height). When the fruit is pressed down
via the fruit dome, at least 1 cm (1/2 inch) of free
space must be left at the bottom of the juicing cone. Cut
off an appropriate slice at the open end of the fruit half
for getting good contact to the juicing cone.
You apply too much pres-
sure to the press arm.
Decrease your juicing speed by reducing the pressure on the
press arm. Push down the press arm just until the motor
starts. This way, you get the maximum amount of juice.
The juice level rises in the
filter basket. The juice
does not flow out into
your juice vessel.
Too much pulp in the filter
basket. The filter basket is
clogged.
Unplug the appliance and empty the filter basket. If
required, rinse stubborn fibres of the pulp from the strai-
ner (see: ‘Operation / Emptying the Filter Basket and
Removing Obstacles’).
Содержание ADVANCED PRO S
Страница 3: ...3 D Entsorgungshinweise 32 Information und Service 32 Gewährleistung Garantie 33 ...
Страница 12: ...12 D IHRE NEUE ZITRUSPRESSE KENNEN LERNEN 2 4 6 5 7 8 1 3 10 11 9 14 13 12 ...
Страница 34: ......
Страница 44: ...EN 44 2 7 8 1 3 10 11 9 14 13 12 KNOWING YOUR NEW CITRUS JUICER 4 6 5 ...