72
vacuum hose down firmly to ensure a tight fit.
5. With a manually adjustable pressure valve at the container lid, ensure that the
valve is in the open position. Otherwise, the container cannot be evacuated.
6.
Shortly
press the VACUUM MARINATE button to switch on the vacuum pump.
While evacuating the container, the VACUUM MARINATE button will flash. The
appliance will operate until the pre-programmed low pressure is reached. The-
reafter the appliance will shut off automatically. The container will be sealed via
the pressure valve of the container.
Note
You may cancel the process at any time by pressing the STOP button. The appli-
ance will stop operation at once and ventilate the vacuum port. However, con-
tainers equipped with a check valve will keep the pressure already reached. If
you wish to stop evacuation at the pressure already reached for containers with
a manually adjustable pressure valve, simply shut the pressure valve at the lid of
the container.
WARNING:
After operation, the interior of the container is under low pressu-
re (vacuum). Even little damages of the container or improper treatment may cause
implosion of evacuated containers. Always handle any evacuated containers with
special care to avoid injuries and damage due to splinters and splashes being
hurled about. Do not expose evacuated containers to heat, mechanical or thermal
shock, or direct sunlight.
7. Depending on the vacuum container used, if necessary, ensure to close the pressu-
re valve at the container lid. Carefully remove the vacuum hose from the container.
8. If you wish to evacuate another container, wait at least 60 seconds before ope-
rating the appliance again. Then start with step 4.
9. Always store evacuated containers where they are protected from mechanical
or thermal shock and direct sunlight.
10. Do not leave the appliance connected to the power supply when it is not in use.
If you do not wish to use the appliance again, remove the vacuum hose from
the appliance. Unplug the power cord from the mains power supply first.
11. Remove the small plug of the power cord from the appliance and cover the
power port of the appliance with the silicone lid.
