Gaspardo ORIETTA Series, Использование и обслуживание

Страница: 50 / 198

USE AND MAINTENANCE
50
ENGLISH
g
cod. G19502812
Maintenance in safety
During work and maintenance operations, use suitable perso-
nal protection gear:
Overalls Gloves Shoes Goggles Helmets
64) Do not proceed with maintenance and cleaning if the power
take-off has not been disconnected first, the engine power
off, the hand brake pulled and the tractor blocked with a
wooden block or stone of the right size under the wheels.
65) Periodically check that the bolts and nuts are tight, and if
necessary tighten them again. For this it would be advisable
to use a torque wrench, respecting the values of 53 Nm for
M10 bolts, resistance class 8.8, and 150 Nm for M14 bolts
resistance class 8.8 (Table 1).
66) During assembling, main-tenance, cleaning, fitting, etc., with
the seeding machine raised, place adequate supports under
the equipment as a precaution.
67) The spare parts must correspond to the manufacturer’s
specifications. Use only original spares .
3.0 INSTRUCTIONS FOR USE
To obtain the best performance from the equipment, carefully
follow what is set up below.
ATTENTION
All maintenance work, adjustments and preparation for
operation, must be carried out with the power take-off of the
tractor disconnected, the seeder on the ground on its
supporting feet, the tractor not running, the wheels blocked
and the key turned off.
3.1 ATTACHMENT THE TRACTOR
The seeder may be attached to any tractor fitted out with a
three-point universal joint.
DANGER
The attachment to the tractor is a very dangerous phase. Be
sure to follow the instructions carefully throughout the
operation.
The correct tractor/seeder position, is determined by placing
the equipment at a distance from the tractor so that the Cardan
joint remains extended by 5-10 cm from its maximum closing
position.
At this point, proceed as follows:
1) Hook the lifter bars onto the pins provided (1, Fig. 7) Block
with the snap split pins. Hook the chains to the lifting bars.
Table 1
1
fig. 7