8
JETI Alarms setup: (only available in adapters from version 2)
After the fuel related menus, the options for the alarms will be displayed. You can set in
these menus the threshold of the alarm for each measure. By default all are set to 0
(disabled). When a read value is lower than the threshold, the display on the TX will
display the alarm and a sound played. We recommend using these alarms only when
used on Jeti modules (JetiBox profi), if you use it is a DS/DC transmitters use the alarms
settings on the TX. All alarms are disabled until the tank capacity is below 98% to avoid
the alarms of Low RPM and Low pump voltage to be triggered during startup phase.
Multiplex Measures Setup:
Multiplex M-Link telemetry can send up to 16 measures from all sensors on board. These
measures are organized as “slots” and displayed on the TX only identified by the slot
number. From factory the data is sent on slots 4 to 9. In order to combine the telemetry
adapter with other sensors on board, even a second engine using another telemetry
adapter, then it is possible to assign each measure to a particular slot in the MPX
system, and also is possible to disable the transmission of some of the measures to save
slots for other sensors.
Scrolling through the menus, you will see all available measures and the current
assigned slot for transmission by the MPX system. You can change the slot where the
measure is transmitted through the +/- buttons, if you want to disable this measure, set
to slot 0. PLEASE NOTE: Only one measure is allowed to each slot. You should check
that the slot you want to use is not used by another measure in the same or another
sensor in the system.
Multiplex Alarms setup:
After the slot assignment menus, the menus to setup the alarms will be displayed. You
can set in these menus the threshold of the alarm for each measure. By default all are
set to 0 (disabled). When a read value is lower than the threshold, the display on the TX
will be set on inverse video and a sound played. Alarms are disabled until the tank
capacity is below 98% to avoid the alarms to be triggered during startup phase.
