4
5
GENERAL ASSEMBLY
Connecting & Disconnecting to
Gas Source
Familiarise yourself with the general information
and safety guidelines located at the front of this
manual.
Check:
1. The cylinder is filled. A sloshing sound will be
heard when shaken.
2. The burner control is in the ‘OFF’ position
Connecting:
1. Ensure cylinder valve is in its full off position.
2. Check for any damage to either the cylinder
connection or the hose. NEVER attempt to use
damaged equipment.
3. When connecting the hose to the cylinder
tighten the nut to a positive stop by hand
or spanner.
4. Open cylinder valve fully. If a leak can be heard
at either end of the hose turn cylinder off and
tighten joint. Wait 5 minutes before re-testing
and use a soapy water solution to check the
joint. If bubbles appear, the connection will
need to be re-tightened.
Disconnecting:
1. Ensure the burner control is in the
‘OFF’ position.
2. Ensure cylinder valve is in the full off position.
For storage and cylinder exchange, disconnect
hose at the cylinder only, DO NOT disconnect hose
from appliance.
LIGHTING PROCEDURE
Burner Operation &
Ignition System Check
1. With cylinder valve in ‘OFF’ position push and
turn the control knob. Check for sparking to the
burner.
2. If spark is not evident at the burner ignition
point, check that the ignition lead is firmly
attached to the control and sparker tip.
3.
Open the door and ensure that it remains
open while lighting the burner.
4. With sparking established turn the cylinder
valve ‘ON’. Then push and turn the control knob
to ‘HIGH’.
5. If the burner fails to light after several attempts
turn off gas supply at cylinder and inspect for
obstructions to gas flow.
If re-ignition is necessary while the appliance is
still hot, you must wait for a minimum of
5 minutes before commencing to re-ignite
(this allows accumulated gas fumes to clear).
IMPORTANT
• Before connecting and disconnecting to gas
source, make sure burner control is
in ‘OFF’ position.
•
Caution:
When the appliance is not in use,
the gas must be turned off at the cylinder.
•
Important:
The appliance control knob must
be in the ‘OFF’ position before opening the
cylinder valve.
• Be aware of the hot door if re-igniting after
use.
• Check performance of burner prior to
installing ceramic stone.
• Do not smoke when attempting to ignite
burner.
• Always use protective gloves when handling
hot components.
• During use the side and top surfaces will
be
HOT.
•
Note:
If for some reason, ignitor fails to
produce a spark at the electrode, appliance
can be lit by a long barbecue match. With
door open insert lighted match into the gap on
the front of the ceramic stone. Push and turn
control knob to ‘HIGH’. Burner ignition can be
checked through this gap.
