Gasmate GM135-019, Руководство пользователя

Страница: 3 / 8

3 2
• The use of extension cords may cause
power voltage loss which will result in
damage to the heater this will NOT be
covered under warranty.
• Always hold the plug when removing it from
the wall, do not pull the cord.
• Always unplug the heater when it is not in
use.
• Do not allow the cord to come in to contact
with the heater surface during operation.
• Do not run the cord under carpeting, mats
or rugs etc. Arrange the cord away from
traffic areas so that it will not be tripped
over.
• Do not twist, kink or wrap the cord around
the heater as this may cause the insulation
to weaken and split.
• This heater is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the heater by
a person responsible for their safety.
• Children should be supervised to ensure
that they do not play with the heater.
• This heater is intended for light domestic
use and not for heavy duty commercial or
industrial use.
• The heater must not be located immediately
below or in front of a socket-outlet.
• CAUTION: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this heater must not be supplied through an
external switching device, such as a timer,
or connected to a circuit that is regularly
switched on and off by the utility.
• Never remove the cover of the heater – in
case of a fault contact a qualified service
person.
• Repairs should only be carried out by
qualified persons using original spare parts.
Failure to do so may result in considerable
danger to the operator.
• Use this heater only as described in this
manual.
• Any other use is not recommended by the
manufacturer and may cause fire, electric
shock or injury.
WARNING: Fire risk exists if this heater is
covered by or positioned close to curtains or
other combustible materials.
NOTE: Ensure that this heater is connected
directly to an outdoor power point.
The electrical system of this heater must be
connected with an automatic circuit breaker
and/or residual current device (RCD). If
uncertain have a qualified electrician check
your electrical system before installation and/
or use.
All electrical connections are made in a dry
area.
Outdoor power points must be weatherproof
and installed by a qualified electrician.
The distributor is not responsible for
incorrectly chosen additional fixing accessories
or any damage which may be caused by an
incorrectly fitted heater.
FOR YOUR SAFETY
Installation
This heater is not designed for use within 1m or
above a water source.
Ensure that the heater is not positioned directly
above, below or in front of a power point or
switch.
This heater is not designed to be used with 3rd
party timer or programmable system.
This electric heater complies with New Zealand
and International standards and safety
requirements. All installations must meet the
requirements of New Zealand Standard
AS/NZS 3000:2007.