- Using a stand underneath the chassis, stabilized the bike.
- Put something under the engine so that the front wheel does not
touch the ground.
- Remove the air purge screw from the upper part of the front forks.
Adjusting the extension
- To adjust the rebound, rotate the adjustment control
(B)
on the
upper part of the front forks using a screwdriver.
- Adjust the rebound according to your preferences under determined
conditions.
-
33
-
CAUTION
Never leave the key in the lock. If the steering is turned to the left
with the key in the lock then this will be severely damaged.
FRONT FORKS
The front fork should always be adjusted for the rider's weight and
track conditions. The adjustments are done in 5 stages:
-Adjust the compression and the rebond.
The range of both is 22 clicks.
If you close (0clicks) the hyfraulic become very hard.
-The standart adjustmenst is 16 clicks for the rebond and 15 clicks
for the compression.
-Rebond: 16 clicks (open).
-Compression: 15 clicks (open).
- Oil level adjustment: The effects of higher or lower fork oil level
are only felt during the final 100 mm of fork stroke. A higher oil level
will make the fork rebound more quickly. A lower oil level will make
the fork rebound more slowly.
- Fork springs: Optional springs are available that are softer and
stiffer than standard K=4.5.
Air Pressure
The standard air pressure for the front forks is atmospheric pressure.
The air pressure in the fork legs increases as operation progresses
and therefore the forks become harder.
(A). Purge bolt.
(B). Adjustment
control.
