After some seconds, and depending on the outside temperature, the
engine will reach a higher and more stable speed. This means that
it has reached normal operation temperature. At this moment remove
the choke by turning the control
A
to the right hand side.
WHAT TO DO WHEN THE ENGINE IS FLOODED
- Close the fuel tap.
- Following the instructions described in
STARTING THE ENGINE
,
operate the starter button with the throttle completely open (full
throttle) and the choke control all the way to the right; release the
throttle control as soon as the engine starts.
22
DRIVING INSTRUCTIONS
Note
If the engine will not start, remove the spark plug and dry it.
See "Removing the spark plug".
- Once the engine is running, open the fuel tap.
Stopping the engine
- Brake the motorcycle and put the gearshift pedal in neutral.
- Completely close the accelerator pedal and use the engine stop
button.
- Rotate the ignition key anticlockwise to the position .
- Close the fuel tap.
STOPPING THE MOTORCYCLE
DANGER
When driving in wet conditions or after washing the motorcycle,
the brakes may be wet. If so, then the braking capacity is reduced
until the braking elements are dry. Drive carefully and lightly apply
both brakes in order to dry them.
WARNING
If the ground is slippery or loose then give preference to the
rear brake.
Depending on circumstances and ground surface, it may be
better to use the front or rear brakes independently.
Gear down gradually using the engine braking capacity.
A
