SGC and SGC Plus User’s Manual
UM SGC v3.0
9 of 15
Cleaning
The detector can be cleaned with a soft damp cloth. Do not use solvents, soaps or polishes. A neutral cleaner, like Mat &
Table Top Cleaner (by ACL Staticide) may also be used.
The sensor screen may be cleaned with a soft brush under clean, warm water. Return the filter to the detector once it
has fully dried.
Hibernation (SGC Plus Only)
When the SGC Plus is not used for extended period of time it can be hibernated to suspend the 24 month operation life
countdown.
SGC Plus Hibernation with the GCT IR Link
1. Check that you have installed the GCT IR Link Software and the GCT IR Link USB connections are
plugged in.
2. Click Read Device on the GCT IR Link Software.
3. Note when the detector is hibernated the event log will be cleared. It is highly recommended to save
the event log by pressing the save event log before hibernating.
4. Click on the Hibernate Button, acknowledge the event log message.
5. Keep in front of the GCT IR Link until the “Hibernate OK” message is displayed at the bottom of the GCT
IR Link Software.
6. Confirm the detector screen is blank.
7. If you encounter any problems please contact GCT customer support at 877-525-0808.
SGC Plus Hibernation with the Clip Dock
1. Check that the Clip Dock is turned on and USB memory is inserted.
2. The Clip Dock is capable of hibernating 4 detectors at one time: place the desired amount of detectors
in the docking station.
3. Press and hold the bump test and calibration buttons down simultaneously for approximately 2
seconds.
4. A successful hibernation will result in a GREEN light on for the corresponding detector number.
5. Note the event log will be automatically stored on the Clip Dock USB memory.
6. Confirm the detector screen is blank.
7. If you encounter any problems please contact GCT customer support at 877-525-0808.
