Garudan GPS/G-10060, Руководство пользователя

Страница: 17 / 69

ANITA ©
MP00006EN_181206 17
6. MAIN ICONS
These icons are used for basic commands. These icons allow changeover between individual modes
of machine (sewing, editing, testing…). The machine is always in general mode after start up of
machine and it only allows opening and sewing created patterns and showing information about
machine. Reasonable icons you can see in the picture 10.
Picture 10: Main icons in general mode
Besides the general mode there is also service mode. This mode extends possibilities of
working. These possibilities are:

creation and editing of patterns

saving of patterns to the machine

settings the parameters of machine

testing interface

interface for changing the firmware of control board
Picture 11: Main icons in service mode
For entering service mode press the icon A7 – Log in . After that you can see the screen where you
have to set the access code (default value is 110585 for older version of software or 67976 for new
version of software) and confirm by pressing OK. If you put the correct code, selection of main icons
will be extended by icons A3-A6. Log out from service mode is done by pressing icon A8 – Log out .
Value of service mode code is possible set by parameter 50 Mechanic password. Value of pattern
programming code is possible set by parameter 59 Edit password (default value is 110585).
www.garudan.cz