HD-2 Operation and Installation Manual
Page 4
Input Voltage Configuration
WARNING
The HD-2 model is equipped with a voltage selection block allowing the HD-2 to be
configured for use in any country.
To check or change the voltage configuration of the HD-2, follow the steps listed below:
All trouble shooting and wiring checks must be performed by a
qualified electrician or authorized plant personnel.
1)
Read the Warning
labels.
All trouble
shooting and wiring
checks must be
performed by a
qualified electrician or
authorized plant
personnel.
2)
Remove the power cord
from the back of the HD-
2.
3)
Using a Torx T-20
driver, remove (3)
screws from each side,
and (7) screws from
both the front and back
in order to remove the
top cover.
