Appendix D - Interconnect Diagrams
GNS 480 (CNX80) Installation Manual
560-0982-01 Rev L
D-25
2345 Turner Road S.E., Salem, OR 97302
Phone: 503.581-8101 http://www.garmin.com
Garmin AT, Inc
FULL STACK
DUAL GNS 480 / MX20 or GMX 200 / SL15 / SL70
GNS 480 INSTALLATION DRAWING
NOTES:
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
2. AT GARMIN AT EQUIPMENT CONNECT SHIELD GROUNDS TO THE REAR OF THE
MOUNTING FRAME ON THE CONNECTOR PLATE -- THE SHIELD LEADS MUST BE LESS
THAN 3.0 ". UNLESS OTHERWISE NOTED, CONNECT OTHER SHIELD GROUNDS TO
AIRCRAFT CHASSIS WITH AS SHORT A CONDUCTOR AS PRACTICAL.
3. GNS 480 SERIAL PORT CONFIGURATION (RX / TX):
SERIAL PORT 1: MAPMX / MAPMX (GNS 480 #1 ONLY)
SERIAL PORT 2: CROSSFILL / CROSSFILL
SERIAL PORT 6: SL70 / SL70
SERIAL PORT 8: ALT ENC / ---
4. MX20/GMX 200 EXTERNAL DATA SOURCE CONFIGURATION:
EXTERNAL GPS POSITION SOURCE: PORT 1
ALTITUDE SOURCE: PORT 1
NAV SOURCE: NONE
5. THE SL70/SL70R MUST HAVE SOFTWARE VERSION 1.3 OR HIGHER IF IT IS DESIRED
TO HAVE BOTH GNS 480'S REMOTELY CONTROL IT.
SL70 SERIAL PORT CONFIGURATION:
ALT SOURCE: SER
BAUD: 9600
TX: EXT
SL70R: GRAY CODE ALT PGM PIN 36 MUST BE LEFT OPEN.
6. EACH GNS 480 SHOULD EACH HAVE ALTITUDE INPUT DIRECTLY. THE SL70/70R DOES
NOT REQUIRE A DIRECT ALTITUDE CONNECTION, SINCE EITHER GNS 480 CAN
SUPPLY ALTITUDE TO THE TRANSPONDER.
7. ALTITUDE ENCODERS ARE NOT GARMIN AT-PROVIDED EQUIPMENT. REFER TO THE
APPROPRIATE ENCODER INSTALLATION MANUAL TO ENSURE PROPER
CONNECTIONS.
8. SHIELDS FOR AUDIO CABLES SHOULD BE GROUNDED AT ONE END AND LEFT
FLOATING AT THE OTHER END. IF SHIELDED AUDIO CABLE IS CARRIED THROUGH
DISCONNECT, CARRY SHIELD GROUND THROUGH DISCONNECT ON SEPARATE PIN.
9. GNS 480 RS232 CHANNEL 6 IS OPTO-ISOLATED, ALLOWING TXD6 FROM EACH
GNS 480 TO BE CONNECTED IN PARALLEL.
IF THE GNS 480 MESSAGE AUDIO OUTPUT IS CONNECTED TO AN UNSWITCHED
AUDIO INPUT, IT IS RECOMMENDED THAT THE THE SL15 AUDIO ACTIVE OUTPUT BE
CONNECTED. THIS OUTPUT IS ONLY AVAILABLE ON CERTAIN SL15 AUDIO PANELS.
ALTERNATE CONNECTIONS ARE SHOWN ON THE SL10/SL15 AUDIO PANEL
INTERCONNECT DRAWING. CONSULT THIS INTERCONNECT DRAWING THE
APPROPRIATE INSTALLATION MANUAL FOR INFORMATION.
THESE SIGNALS ALSO GO TO THE AUTOPILOT AS APPROPRIATE.
12.THIS DIAGRAM IS PROVIDED TO SHOW THE INTERCONNECTION BETWEEN GARMIN
AT UNITS. FULL WIRING DIAGRAMS FOR EACH UNIT ARE PROVIDED IN THE
APPROPRIATE INSTALLATION MANUALS. REFER TO ALL DOCUMENTATION TO
ENSURE SUCCESSFUL INSTALLATION.
THE AUDIO MESSAGE OUTPUT FROM GNS 480 #2 SHOULD NOT BE CONNECTED.
REFER TO SL10/SL15 AUDIO PANEL INTERCONNECT DIAGRAM FOR ADDITIONAL
INFORMATION ABOUT CONNECTING THE PA MUTE OUTPUT.
Initial Release
-
03/31/03
Description
Rev
Date
SL15
AUDIO PANEL
13
Bot
NAV 2 AUDIO IN (HI)
GNS 480 #2
(Nav/Com #2)
23
20
AUDIO GND
NAV AUDIO OUT
1
3
AUDIO GROUND
GNS 480 #1
(Nav/Com #1)
14
13
8
7
4
23
20
COM MIC IN HI
PTT
COM HEADPHONE OUT
COM AUDIO GND
COM MIC IN LOW
AUDIO GND
NAV AUDIO OUT
P4
P7
NAV 1 AUDIO IN (HI)
COM 1 AUDIO IN (HI)
COM 1 MIC OUT (HI)
COM 1 MIC KEY OUT
12
9
P
R
20
Top
AUDIO ACTIVE OUT
77
AUDIO INHIBIT IN
P5
T
UNSWITCHED AUDIO
#1 IN (HI)
40
43
MESSAGE AUDIO OUT
MESSAGE AUDIO GND
10
H
V
COM 2 AUDIO IN (HI)
COM 2 MIC OUT (HI)
COM 2 MIC KEY OUT
14
13
8
7
4
MIC 1
TX KEY
HEADPHONE
AUDIO GND
MIC GND
P7
CDI / HSI #1
(MD200-306 shown for
reference)
OBS_C {R Lo}
OBS_D {S1}
OBS_E {S3}
BACK COURSE
OBS_F {S4}
OBS_G {S2}
OBS_H {R Hi}
1
2
3
5
4
6
18
24
NAV ANNUNC
17
GPS ANNUNC
24
7
26
25
15
16
34
17
18
OBS_C {R Lo}
OBS_D {S1}
OBS_E {S3}
BACK COURSE
OBS_F {S4}
OBS_G {S2}
OBS_H {R Hi}
GPS IND OUT
NAV IND OUT
MX20/GMX 200
37-pin connector
P1
23
SERIAL GND 1
RS232 RXD1
4
5
RS232 TXD1
23
4
5
PORT 1 GND
PORT 1 IN
PORT 1 OUT
4
P7
CDI / HSI #2
(MD200-306 shown for
reference)
OBS_C {R Lo}
OBS_D {S1}
OBS_E {S3}
NAV + VALID
NAV - VALID
+TO
+FROM
CDI + L
CDI + R
BACK COURSE
OBS_F {S4}
OBS_G {S2}
OBS_H {R Hi}
GS+ VALID
GS- VALID
GSI + UP
GSI + DOWN
1
2
3
5
4
6
7
8
16
9
10
15
14
11
12
13
18
24
NAV ANNUNC
17
GPS ANNUNC
24
7
26
25
10
29
12
11
14
13
15
16
34
28
32
30
31
17
18
OBS_C {R Lo}
OBS_D {S1}
OBS_E {S3}
MAIN CDI + VALID
MAIN CDI - VALID
MAIN CDI +TO
MAIN CDI +FROM
MAIN CDI + L
MAIN CDI + R
BACK COURSE
OBS_F {S4}
OBS_G {S2}
OBS_H {R Hi}
MAIN GS+ VALID
MAIN GS- VALID
MAIN GS + UP
MAIN GS + DOWN
GPS IND OUT
NAV IND OUT
Altitude Encoder
or Digitizer
44
30
SERIAL GND 7/8
RS232 RXD8
Serial
Altitude
Output
6
7
SERIAL GND 6
SL70/70R
SERIAL GND
RXD
TXD1
P5
42
3
5
4
5
SERIAL GND 6
P5
42
44
30
SERIAL GND 7/8
RS232 RXD8
P1
23
SERIAL GND 2
RS232 RXD2
21
22
RS232 TXD2
23
21
22
SERIAL GND 2
RS232 RXD2
RS232 TXD2
P1
P5
TXD1
GND
8
8
8
8
8
8
8
3
9
10
P7
P4
6
10
TXD2
GND
10
RS232 TXD6
22
RS232 RXD6
2
RS232 RXD6
2
RS232 TXD6
22
22
TXD2
SERIAL GND
24
NAV + VALID
NAV - VALID
CDI + L
CDI + R
GS+ VALID
GS- VALID
GSI + UP
GSI + DOWN
7
8
16
15
14
11
12
13
10
29
14
13
28
32
30
31
MAIN CDI + VALID
MAIN CDI - VALID
MAIN CDI + L
MAIN CDI + R
MAIN GS+ VALID
MAIN GS- VALID
MAIN GS + UP
MAIN GS + DOWN
+TO
+FROM
9
10
12
11
MAIN CDI +TO
MAIN CDI +FROM
11
11
Clarified Note 5.
A
05/16/03
Added Note 13 for audio from
2nd CNX80.
B
06/20/03
P5
40
43
MESSAGE AUDIO OUT
MESSAGE AUDIO GND
N/C
N/C
13
13
18
PA MUTE (OUT)
Added SL15 PA Mute output
connection to CNX80. Updated
company name to Garmin AT in
notes.
C
08/25/03
14
14
Corrected pin numbers for
SL70/70R RxD and TxD1.
D
10/30/03
Changed unit name to GNS 480.
Updated Note 3 for new serial
port 2 configuration name.
E
05/20/03
Added GMX 200
F
10/30/08
Figure D-12. Full Stack with Dual GNS 480s Interconnect Diagram
Содержание GNS 480
