7
TAKEOFF TOUR
190-00356-00 Rev B
Fuel On Board and Checklists
The
instrument panel self-test page
includes selec-
tions to set fuel on board (FOB) to full capacity and
access the
checklists page
. This allows you to quickly
set fuel to full limits and display any checklists you’ve
entered, such as start up or takeoff checklists.
To set fuel on board to full (if not provided by
sensor):
1. Turn the
large right
knob to hghlght “Set
Full Fuel?”.
Select “Set Full Fuel?” to set fuel on board
(FOB) to full capacity.
2. Press
ENT
and verfy that fuel on board
(“FOB”) now matches the fuel capacty (CAP)
figure. Fuel on board wll now be reduced, over
tme, based on the fuel flow (FF) figure.
Fuel On Board & Checklists
To view the checklists page:
1. Turn the
large right
knob to hghlght “Go To
Chklst?” and press
ENT
.
Select “Go To Chklist?” to display the check-
list page and any available checklists. The
400W-series unit can hold up to nine check-
lists with up to 30 entries in each checklist.
2. Turn the
large
right
knob to select the desred
checklst, then follow the steps n
Section 9
- Aux Pages - Utility Page
to execute each
step n the selected checklst.
3. Once you complete the desred checklst(s),
press the
small right
knob to return to the
checklsts page. Press the
small right
knob
agan to return to normal operaton on the
satellte status or map pages.
Once you’ve verified instrument operation with
the instrument panel self-test page displayed,
press the ENT key.
The
satellite status page
will appear as the 400W-
series unit begins to collect satellite information. An
“Acquiring” status will be displayed on the
satellite
status page
, and the signal strength of any satellites
received will appear as “bar graph” readings. This is
a good indication that you are receiving signals and a
position fix will be determined. Following the first-
time use of your 400W-series unit, the time required
for a position fix will vary—within two minutes.
190-00356-00_0B.indd 7
9/7/2007 2:48:59 PM
