Garland SRW286A, Инструкция по установке и эксплуатации

Страница: 7 / 32

4517957 Rev. 2 (06/05) Page 7
• In Canada, the installation must comply with local
codes, or in the absence of local codes, with the
Installation Codes for Gas Burning Appliances and
Equipment CAN/CGA-B149.1 and CAN/CGA
B149.2, (latest edition), and with the Canadian
Electrical Code C22.1 (latest edition).
In the United States the installation must comply
with the National Fuel Gas Code ANSI Z223.1,
(latest edition), NFPA No. 54, (latest edition), and
the National Electrical Code ANSI/NFPA 70,
(latest edition), and/or local codes to ensure a safe
and efficient operation.
• This equipment must be electrically grounded in
accordance with local codes, or in the absence of
local codes, with National Electrical Code, ANSI/
NFPA 70, or the Canadian Electrical Code, CSA
C22.2, as applicable.
• The appliance and its individual shut-off (supplied
by others) must be disconnected from the gas
supply piping system during any pressure testing of
the system at pressures in excess of 1/2 PSIG (3.45
KPA). The appliance must be isolated from the gas
supply piping by closing its individual manual shut-
off (supplied by others) during any pressure testing
of the gas supply piping system at test pressures equal
to or less than 1/2 PSIG (3.45 KPA).
• Adequate clearance must be provided for servicing
and proper operation.
Clearances
Minimum installation clearance to adjacent combustible
walls and type of floor or base:
MINIMUM CLEARANCES STW286A
LOCATION CLEARANCE
Left Hand Side 7" (178mm)
Right Hand Side 7" (178mm)
Rear 6" (152mm)
TYPE OF FLOOR OR BASE
Combustible
Location
The range should be installed on a firm, smooth and
level floor designed to withstand the weight of the fully
laden appliance. Any openings in the wall beside the
appliance should be sealed.
Appliances Equipped with Casters
• The installation shall be made with a connector
that complies with the Standard for Connectors
for Moveable Gas Appliances, ANSI Z21.69/CGA
6.16, (latest edition), addenda Z21.69a-1989, and
a quick-disconnect device that complies with the
Standard for Quick Disconnects for Use with Gas
Fuel, ANSI Z21.41/CAN1 6.9, (latest edition).
• The front casters on the appliance are equipped
with brakes to limit the movement of the appliance
without placing any strain on the connector or
quick disconnect device or its associated piping.
• Be aware; required restraint is attached to a bracket,
which is located on the rear caster closest to the
gas connection. If disconnection of the restraint is
necessary, be sure to reconnect the device after the
appliance is returned to its original position.
Ventilation & Air Supply
The area in which the appliance is installed must be
adequately ventilated to provide air for combustion,
removal of products of combustion and removal of
steam, etc. Proper ventilation is essential for optimum
performance.
The ideal method of ventilating equipment is the use
of a properly designed canopy which should extend six
inches, (152mm), beyond all sides of the appliance(s) and
six feet, six inches, (1981mm), above the floor.
A strong exhaust will create a vacuum in the room. For
an exhaust vent to work properly, replacement air must
enter the room. The amount of air that enters must equal
the amount exhausted. All gas burners and pilots need
sufficient air to operate. Large objects should not be
placed in front of the appliance(s) which would obstruct
the flow of air into the front.
INSTALLATION continued