Garland MWE-9501, Руководство по эксплуатации

Страница: 25 / 48

1. PRESS and HOLD the "PROG" button for five, (5),
seconds . (Display will flash GC450 and the program
version number).
2. PRESS the "PROG" button twice to display "SYSTEM
SETUP".
3. PRESS
the
"MENU"
button until
"STANDBY ALERT
(YES/NO)".
4. PRESS
the
"UP ARROW"
button (↑) to
change (YES/
NO).
5. PRESS the "PROG" button to display "SYSTEM
SETUP".
6. PRESS the "RIGHT ARROW" button (→) to return
to the normal OPERATING MODE.
To Change the Standby Alert Feature - EPROM
Chip Ver. 6.20 and higher
25
SYSTEM SETUP
To Change Start Delay Timer
1. PRESS and HOLD the "PROG" button for five, (5),
seconds
. (Display will flash GC450 and the program
version number).
2. PRESS
the
"PROG"
button
twice
to display
"SYSTEM
SETUP".
3. PRESS and HOLD the "UP ARROW" ( ↑ ) button for
ten, (10), seconds , "GAP CALIBRATION" will be
displayed.
4. PRESS the "MENU" button. The hold feature will
display “OFF”.
5. HOLD the “RIGHT ARROW”
(→) for ten, (10),
seconds, the “(ON / OFF) WILL FLASH”.
6. PRESS the “UP ARROW” (
↑
)
to change the safety
(ON/OFF).
7. PRESS
the “
FUNCTION
” button to display “DELAY
TIME:”
8. PRESS the “ UP ARROW ” ( ↑ ) to change the delay time
seconds in increments of .5 seconds.
9. PRESS the “ PROG ” button to display “ SYSTEM
SETUP ”.
10. PRESS
the “
RIGHT ARROW
” button (→) to return to
the normal
OPERATING MODE.
To Enable / Disable Multi-Stage Cooking - EPROM
Chip Ver. 7.XX and higher
1. PRESS
and
HOLD
the
"PROG"
button for
five, (5),
seconds
. (Display will flash GC450 and the program
version number).
2. PRESS
the
"PROG"
button
twice
to display
"SYSTEM
SETUP".
3. PRESS the "MENU" button until “MULTI GAP
CLAM” is displayed .
4. PRESS and HOLD the "RIGHT ARROW" button ( →
) until the (YES/NO) begins to flash.
5. PRESS
the
"UP ARROW"
button (
↑
) to change
“YES” to “NO” or “NO” to “YES”
.
6. PRESS the “PROG” button
7. PRESS
the
"RIGHT ARROW"
button ( → ) to
return
to
the normal
OPERATING MODE.
PROGRAMMING
NOTE: To Determine your version EPROM chip. PRESS and HOLD the PROG button for approximately 5 seconds. The
controller will flash “GC450 - V. X.XX”. Eprom Chips are available by calling your local factory authrorized service center.