Garland CHOPPER 406 VE, Инструкция по эксплуатации

Страница: 39 / 120

English English
39/120
5.2.2. ASSEMBLY OF THE WORK TABLE
Depending on the length of the cut wood, the table
can be set to three heights - 570 mm, 770 mm, and
1,060 mm, set the table into the required position (1).
Secure the table with the lever (2) on both sides.
5.2.3. ADJUSTMENT OF THE BLADE’S TRAJECTORY
Working capacity can be increased for pieces smaller
than 50 cm, limiting the movement towards the back
of the cutting blade.
Place a small piece of wood in the bandsaw table and
move the blade up to 2 cm by up wood, switch the
bandsaw to shutdown (red button of the switch and
disconnect the plug) and limit the rod movement back
(1) at the desired height with the adjustment screw (2).
5.3. START-UP
5.3.1. PLACEMENT OF THE MACHINE
Make sure you install the machine on a stable surface
and in a vertical position in an area away from a wall
and where you will have enough room to be able to
work.
5.3.2. CHECKPOINTS BEFORE COMMISSIONING
The voltage and current supply must comply with the
indications on the rating plate. Before starting work,
make sure that the appliance operates correctly and
its operation is safe.
Do not use machine is if it is damaged or incorrectly
regulated.
5
6 6
2
1
1
2